After tuning my vref, the printer was missing steps still. I pulled the trigger and am swapping from the 4.2.2 to the 4.2.7 creality board to see if that resolves the issue.

While i was in there, I figured I’d put another z axis motor on there.

Do you guys have any recommendations on firmware or should I just stick with creality’s?

  • Koopa_Khan@lemmy.worldOPEnglish
    3·
    22 days ago

    Instructions unclear, I’ve given the whole printer a bath and now all it does is blow bubbles

    • SpaceNoodle@lemmy.worldEnglish
      2·
      22 days ago

      I actually worked at a facility where we really did thoroughly clean (inkjet) printers since the customer returns would get NASTY.

      Some of the electronics, like those on the printer head, are actually fine with a good rinsing as long as you then thoroughly dry them off with the air hose.

      This surely does not transfer to modern 3D printers.

        • SpaceNoodle@lemmy.worldEnglish
          1·
          21 days ago

          The difference was that these printers were installed in bakeries, and were printing edible ink onto edible paper. If the owners didn’t keep up on basic maintenance or general cleanliness, there could be a fair amount of mold, or - far more often than you’d hope - lots of roaches.