I just came across this and thought I’d share. I’ve struggled to get headers and IC’s off boards after soldering them on backwards/upside down. This video shows a cool trick with a piece of copper wire that makes them very easy and quick to get off without expensive tooling. I was thoroughly impressed. Hope someone else finds this useful too.
I was ready to shit on this but I could definetely see some uses when there are a lot of through hole pins. I’d be a little worried about keeping the heat distribution even though.
I thought it might be useful to move the iron back and forth a little for long rows. Wouldn’t be perfectly even but would be better than concentrating heat in the center.
Well the copper should disperse the heat fairly quickly. It should be okay.