rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish · edit-21 年前stringing suggestions?message-squaremessage-square33fedilinkarrow-up123arrow-down10file-text
arrow-up123arrow-down1message-squarestringing suggestions?rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish · edit-21 年前message-square33fedilinkfile-text
minus-squareGorroth@lemmy.worldlinkfedilinkEnglisharrow-up1·1 年前No, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
minus-squareimgonnatrythis@lemm.eelinkfedilinkEnglisharrow-up2·1 年前Ok. I’m going to give this a try thx.
No, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
Ok. I’m going to give this a try thx.